AD10€10 off with code AD10 at checkout
Design

QR code on an advertising screen: how large does it need to be?

Christian Starzengruber

Christian Starzengruber

Founder, adyoutiser

6 November 20268 min read10
QR code on an advertising screen: how large does it need to be?

How large should a QR code on an advertising screen be? The 10:1 rule, a table for every screen format in the network in centimetres and pixels, and a 3-minute scan test.

In short: Use the 10:1 rule of thumb: a QR code with 25 cm sides can be scanned from about 2.5 m. On a 75-inch portrait screen (93 cm wide) that is just over a quarter of the image width, so roughly 290 pixels in a 1080-pixel-wide creative. Never make the code smaller than a quarter of the creative's width, keep it on screen for the full 10 seconds, and shorten the URL so the dots stay large.

Most guides on QR code size are written for flyers and business cards: 2 cm, done. On a screen that people pass at two metres, that is a grey smudge. Here is how large the code should be on every screen format in our network, in centimetres and in pixels.

How large does a QR code on an advertising screen need to be?

Large enough that its side length is at least one tenth of the scanning distance. Scanning from 2 m needs 20 cm.

The 10:1 rule is a rule of thumb used by QR code providers, not a standard. It assumes good lighting, high contrast and a simple code. With backlight, reflections or a dense code, calculate with 8:1 instead. In the end, your own test decides (see below).

What matters is which distance you assume. Not the distance from which the screen is visible, but the one at which someone stops and raises their phone. That is usually closer than you think, but rarely closer than 1.5 m.

Which size fits which screen in the network?

A quarter of the image width is a good starting point. On a 55-inch screen that is 17 cm, on 86 inches 27 cm.

All screens in Vienna and Bratislava run in 9:16 portrait, the LED wall in Amstetten in 4:3 landscape. Dimensions are calculated from the diagonal:

ScreenWidth × height¼ of widthScan distance at 10:1Where in the network
55 inch, portrait68 × 122 cm17 cm~1.7 mHandelskai Pier 01–09 and 12 (Vienna 2nd district), HUMA 6 entrance left and middle (Bratislava)
75 inch, portrait93 × 166 cm23 cm~2.3 mMariahilfer Straße 125, Julius-Tandler-Platz
80 inch, portrait100 × 177 cm25 cm~2.5 mFranz-Josefs-Kai
86 inch, portrait107 × 190 cm27 cm~2.7 mJosefstädter Straße 99, Plankengasse 1
LED wall, landscapeapprox. 192 × 144 cm48 cm~4.8 mAmstetten

If you want people to scan from further away, make the code larger, not the text around it. A third of the width still works on a portrait screen. More than that takes space away from your offer. All locations with photos are on the map.

How many pixels does the QR code need in the creative?

A quarter of the creative's width: 270 pixels in a 1080-pixel-wide creative, 540 pixels at 2160 pixels. Each dot of the code should end up at least 6 pixels wide.

A QR code is made of square modules, the black and white dots. Under ISO/IEC 18004, version 1 has exactly 21 × 21 modules, and each further version adds 4 per side. On top of that comes a quiet zone of 4 modules on every side where nothing else may appear.

How to check:

  1. Count the modules on one side (or read the version in your QR generator).
  2. Add 8 for the quiet zone.
  3. Divide the code's pixel width by that number.

Example: version 2 has 25 modules, plus 8 makes 33. At 270 pixels that is just over 8 pixels per module. Fine. Version 6 has 41 modules, plus 8 makes 49. At the same 270 pixels you get just over 5 pixels per module. That is tight, so make it larger or shorten the URL.

Export the code as PNG or SVG at full size and do not scale it with smoothing. Blurred edges turn sharp modules into grey borders. The resolution your whole creative needs is in the creative specs.

Why does a short URL make the code easier to scan?

The more characters in the code, the more modules it needs. On the same area, each dot gets smaller and harder to scan.

A short address like yourshop.at/q fits into version 1 or 2. A long URL with UTM parameters of around 100 characters needs version 6 at medium error correction, so 41 instead of 25 modules per side. The code looks the same size, but each dot is about 40 % smaller.

The fix is a short path on your own domain that redirects to the long URL. Then you can change the parameters later without uploading the creative again. How to set up the redirect with UTM parameters for measurement is explained in UTM and QR links for screen advertising.

A logo in the middle of the code only works with high error correction (level H), which again needs more modules. If space is tight: drop the logo and place it next to the code.

How long does the QR code need to be visible?

The full 10 seconds of your creative. Anyone who first has to get their phone out of their pocket needs that time.

With adyoutiser you buy a share of airtime, not a fixed number of plays. 10 % means 6 seconds per minute. On screens run by an operator's own system you book one of 12 slots of 10 seconds in the loop, so your creative comes up about every 2 minutes. Between two appearances the code is gone. So:

  • Don't animate it. Show the code from second 1, in the same place. A code that flies in after 6 seconds has 4 seconds left.
  • Not in the corner. At the bottom edge, heads and prams cover it. The lower third above the edge or the centre is safer.
  • Add one sentence. "Scan for 10 % off your first appointment" says why someone should raise their phone. A bare code says nothing.

Where is a QR code worth it at all?

Where people stand and wait. People walking past rarely scan.

In the network that includes the boat landing stages at Handelskai, the passenger port in Bratislava and the railway station at Julius-Tandler-Platz. On a shopping street like Mariahilfer Straße, glances are usually shorter. There a short, memorable voucher word is often the better answer: "Say 'PIER' at the till." People can remember it without a phone.

Best is both: code and word. Then you measure scans via the redirect and redemptions at the till separately.

How do you test the code before uploading?

Scaled down. Show the creative on your laptop and scan from a scaled-down distance.

It takes 3 minutes:

  1. Open the creative full screen on your laptop and measure the code's width on the display, e.g. 5 cm.
  2. Work out the scale: on the 75-inch screen it would be 25 cm, so a factor of 5.
  3. Divide the planned scanning distance by the same factor: 2.5 m ÷ 5 = 50 cm.
  4. Scan from 50 cm with two different phones, without zoom. If it works on the first try, you are good.
  5. Open the link and check that the page loads quickly on a phone and the offer is at the top.

Dark on light is the safe default. Colours work as long as contrast stays high. Light grey on white or red on black often fails.

What still has to be on the creative itself?

Everything the law requires on the ad itself. A QR code does not replace a mandatory statement.

If you advertise a price, the gross price goes directly on the creative, not behind the link. Details are in Prices in ad creatives. Every creative is reviewed before it starts, by AI and a human. How that works is explained in Creative review at adyoutiser. Whether your link leads to the right page is something you test yourself.

Frequently asked questions

How large does a QR code on a poster or screen need to be?

At least one tenth of the scanning distance. For 2 m that is 20 cm, for 3 m 30 cm. On a portrait advertising screen, a quarter of the image width is a good starting point.

How many pixels does a QR code need in a video or image?

Plan for at least 6 pixels per module plus the quiet zone. A short code (version 2) then needs at least 200 pixels; in a 1080-pixel-wide creative, 270 pixels is comfortable.

Yes, with error correction level H. That makes the code denser, so make it closer to a third of the image width or put the logo next to it.

What does it cost to test a creative with a QR code?

The minimum order is €2, and one day is enough. What a day on individual screens costs is shown in Advertising for my shop in Vienna: €100, €300, €1,000.

Does adyoutiser count the scans?

No. On screens with our player we count the plays. You count scans through your own redirect or analytics tool.

Code measured, link tested? Then book your first day at /book.

Share:
qr-codewerbemotivmotivgestaltungwerbebildschirmtracking
Christian Starzengruber
Author

Christian Starzengruber

Founder, adyoutiser

Ich habe adyoutiser 2025 gestartet, weil Bildschirmwerbung keine Agentur brauchen sollte. Du wählst den Screen auf der Karte, lädst dein Motiv hoch und zahlst online. Firmensitz: Bratislava.

LinkedIn

Related Articles

Live

Ready to launch your first DOOH campaign?

Book a screen in Vienna and Bratislava. From €2. One day is enough. No agency.

Book advertising

Get new posts in your inbox.

Monthly max. No spam.

Max. 1 email a month: new screens, locations and offers from adyoutiser. You confirm by email, unsubscribe in one click. Privacy policy.

Comments

Your comment will appear after review

On air · live in 5 min · every play counted

Upload. Map. Live.

From €2 minimum order · minimum 1 day. No agency, no sales call, no annual contract.

until live
5 min
min. order
€2
minimum term
1 day